Reusable Adult Soft tip spo2 Sensor Probe adult finger clip spo2
sensor for GE Marquette compatible 11pin
Compatibility:
| Manufacturer | Model |
|---|
| GE Healthcare > Corometrics | 128, 250, 250cx, 259, TRAM 450SL |
|---|
| GE Healthcare > Critikon > Dinamap | Carescape B650, Carescape B850, Carescape V100 |
|---|
| GE Healthcare > Marquette | Dash 2500, Dash 3000, Dash 4000, Dash 5000, Dash Series, Eagle, PDM
Module, Procare B40, SOLAR, Solar 8000, Solar 8000M, TRAM Modular,
Tram 451, i/9500, x50SL Series |
|---|
The process flow for manufacturing is as follows:
Wire cutting: The wires are cut to the required lengths.
Sheath Stripping: The outer sheath of the wires is stripped to
expose the inner conductors.
Shield Twisting: If there is a shield layer, it is twisted around
the inner conductors for added protection against interference.
Sleeve Crimping: The sleeves or connectors are crimped onto the
ends of the wires to facilitate proper connections.
Tin Soldering: The exposed conductors are coated with tin solder to
enhance conductivity and ensure secure connections.
End Pressing: The crimped sleeves or connectors are securely
pressed onto the ends of the wires.
Set Plastic Shell: A plastic shell or housing is set around the
assembled components for structural integrity and protection.
Electrical Test: The assembled components are tested for proper
electrical functionality to ensure they meet the required
specifications.
Internal Mold Forming: If needed, an internal mold is formed to
provide additional support and structure to the assembled
components.
Outer Mold Forming: An outer mold is formed around the internal
components to provide further protection and aesthetic appeal.
Visual Inspection: The assembled product is visually inspected to
check for any defects or abnormalities.
Electrical Test: Another round of electrical testing is conducted
to ensure the product's electrical performance.
Thread End of Network: If applicable, the network thread end is
prepared for connection.
Sheath Stripping: The outer sheath of the network thread end is
stripped to expose the inner conductors.
Shield Twisting: The shield layer is twisted around the inner
conductors for added protection.
Tin Soldering: The exposed conductors are coated with tin solder
for secure connections.
Chips Welding: Chips or electronic components are welded onto the
network thread end.
Glue Dispensing: Adhesive or glue is dispensed to secure components
and provide stability.
Assembly: The various components are assembled together according
to the product design.
Final Test: The fully assembled product undergoes a final round of
testing to ensure it meets all specifications and standards.
Packaging: The finished product is packaged and prepared for
shipping or distribution.
This process flow outlines the general steps involved in
manufacturing the product. However, please note that specific
details and variations may exist depending on the product and
manufacturing requirements.
Compatible
MR Water Trap Product Manuals.pdf
